Table of Contents

CTE ACU1

The ACU1 connector displays information related to the CTE ACU1 Change Over device.

About

This connector uses an SNMP interface to communicate with the ACU1 device. It displays the parameters in a manner similar to the web interface of the device.

Installation and configuration

Creation

This connector uses an SNMP connection and requires the following input during element creation:

SNMP Connection:

  • IP Address/host: The polling IP of the device, e.g., 10.145.1.12.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string required to read from the device. The default value is public.
  • Set community string: The community string required to set to the device. The default value is private.

Usage

ACU Status Page

This page contains general information about the device, such as:

  • Operating Mode
  • Temperature
  • Power Supply Voltages
  • ...

Tx Status Page

This page displays Tx A and Tx B status parameters.

Configuration Page

This page displays the configurable parameters, such as:

  • Safety Mode
  • Failure Delay
  • Auto Change Time
  • ...

Alarms Page

This page displays the device alarm status, with parameters such as:

  • Power Supply Failure
  • System Failure
  • ...

Event Table Page

This page displays a table that can be used to configure which parameter changes should generate a a trap or send an email.

Web Interface Page

This page displays the web interface of the device.

Improve this page