Table of Contents

CTE FMTX1

The FMTX1 connector displays information related to the 1kW Transmitter device.

About

This connector uses an SNMP interface to communicate with the FMTX1 device. It displays the parameters in a manner similar to the web interface of the device.

Installation and configuration

Creation

This connector uses an SNMP connection and requires the following input during element creation:

SNMP Connection:

  • IP Address/host: The polling IP of the device, e.g., 10.145.1.12.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string required to read from the device. The default value is public.
  • Set community string: The community string required to set to the device. The default value is public.

Usage

System Parameters Page

This page contains general information about the device, such as:

  • Stand-By status
  • Frequency Output
  • Temperature
  • System Date/Time
  • ...

Network Parameters Page

This page displays generic network parameters, such as:

  • IP Address
  • Netmask
  • Trap Destination
  • TFTP Server IP Address

Real Time Alarms Page

This page displays the device alarm parameters, such as:

  • Excessive SWR
  • Power Amplitude Overheat
  • Power Supply Overload

Web Interface Page

This page displays the web interface of the device.

Improve this page