Castlerock SNMPc Node
This connector displays the details of a device connected to the Castlerock SNMPc.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | This connector is used for the created DVEs of one specific node found in the Node Table on the Device page of the parent connector Castlerock SNMPc. Note that the DVE is only created if the specific cell is toggled (see Castlerock SNMPc) and this creation can be undone. This connector is automatically generated by the connector Castlerock SNMPc range 1.0.0.x. | - | - |
| 2.0.0.x [SLC Main] | This connector is used for the created DVEs of one specific device found in the Devices Table on the Known IP Addresses page of the parent connector Castlerock SNMPc. Note that the DVE is only created if the specific cell is toggled (see Castlerock SNMPc) and there is a view with the same name as the Site Name of the device. This creation can be undone. This connector is automatically generated by connector Castlerock SNMPc range 2.0.0.x. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | N/A |
| 2.0.0.x | N/A |
Configuration
DVEs running this connector can only be created via the parent connector. For more details on how to set up a connection with the device, see Castlerock SNMPc.
How to use
Range 1.0.0.x
The General page of the connector contains all the raw data that is stored for the node (corresponding to a specific entry in the SNMPc Node Table). The information is updated once every hour.
The Traps page is synchronized with the Traps table in the parent connector. However, this page shows only the traps for this specific node. The Map ID is the foreign key used to filter out his data.
This Info Events page is synchronized with the Info Events table in the parent connector. However, this page only shows the info events for this specific node. The Map ID is the foreign key used to filter out his data.
Range 2.0.0.x
This General page contains a summary consisting of the IP Address, Device Name, and Site Name of the DVE. Next to this summary, you can find the Traps Table, which is fully synchronized with the Traps Table in the parent connector. However, this table only shows the traps for this specific device. The IP Address is the foreign key used to filter out his data.