Table of Contents

Cisco Conductor

This connector is used to monitor the Cisco Conductor device.

About

This connector uses SNMP to retrieve basic information from the device (processors, disk storage, etc.).

Installation and Configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP Connection:

  • IP address/host: The polling IP of the device, e.g., 10.11.12.13.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string used when reading values from the device. The default value is public.
  • Set community string: The community string used when setting values on the device. The default value is private.

Usage

This connector contains 4 pages.

Device

This page displays the Hr Device Table, which lists the devices contained by the host.

Processor

This page displays the Hr Processor Table, which lists the processors contained by the host.

Storage

This page displays the Hr Storage Table, which lists the logical storage area on the host.

TCP

This page displays the Tcp Conn Table, which contains information related to the TCP connection.

Improve this page