Table of Contents

Cisco Panorama SL

This connector is used to display information related to the Cisco Panorama SL device.

About

This connector uses SNMP to communicate with the Cisco Panorama SL device.

Installation and configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP Connection:

  • IP Address/host: The polling IP of the device, e.g., 10.145.1.12.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string required to read from the device. The default value is public.
  • Set community string: The community string required to set to the device. The default value is public.

Usage

General Page

This page displays Service Layer rates, such as the Total HTTP Sessions Rate, Total Bytes Sent Rate, etc.

Traps Page

This page displays a table with the traps received from the device.

Improve this page