Clear-Com Central Switch Unit
The CSU is a matrix to enable push-to-talk communication between network operators and customers.
This connector uses a serial connection to communicate with the device.
About
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version. | No | Yes |
| 1.1.0.X | Connector review; new features. | No | Yes |
| 1.1.1.X | Minimum DataMiner version increased to 10.3.11. | No | Yes |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | HCI 2.0 |
| 1.1.0.x | HCI 2.0 |
| 1.1.1.x | HCI 2.0 |
Configuration
Connections
Serial Connection — Main
This connector uses a serial-over-IP connection connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
Usage (1.0.0.x)
General
This page displays general-purpose information such as Master Uptime and Reset Flags.
Panel
On this page, you can fill in the necessary information to manually send a Key Panel Assignment command. It contains parameters such as Card Number, Port Number, Destination Port, Key Number, Panel Type (unused), and Destination Type.
Crosspoints
This page contains a 512x512 matrix, which displays the current crosspoints.
Configuration
On this page, you can configure the necessary information to send notifications to the manager element. The most important parameters are DMA ID, Element ID, Other Parameter ID, and a toggle button to enable or disable notifications.
Usage (1.1.0.x)
General
This page displays general-purpose information such as the status of the CPU and Reset Flags.
Crosspoints
This page contains a 512x512 matrix, which displays the current crosspoints.
Crosspoint Levels
This page displays the crosspoints, inputs, and outputs levels.
Conferences
A tree control displays all the Conferences and the associated Ports. It is possible to add a new port to a conference and to set the type of the connection. You can also add or remove conferences.
GPIO/SFO
This page displays the status of the GPIO/SFO cards.
Panels
This page displays the status of the panels of the device.
System Cards
This page displays the status of the system cards and the system RCUs.
Alarms
This page displays the device alarms.
Matrix
On this page, you can check the current matrix configuration.
Usage (1.1.1.x)
General
This page displays general-purpose information such as status of the CPU and Reset Flags.
Configurations
On this page, you can change the configuration of the connector itself, e.g., dynamic polling.
Crosspoints
This page contains a 512x512 matrix, which displays the current crosspoints.
Crosspoint Levels
This page displays the crosspoints, inputs, and outputs levels.
Conferences
A tree control displays all the Conferences and the associated Ports. It is possible to add a new port to a conference and to set the type of the connection. You can also add or remove conferences.
GPIO/SFO
This page displays the status of the GPIO/SFO cards.
Panels
This page displays the status of the panels of the device.
System Cards
This page displays the status of the system cards and the system RCUs.
Alarms
This page displays the device alarms.
Matrix
On this page, you can check the current matrix configuration.