Cobham PRORXB SNMP
This connector uses SNMP in order to communicate with the Cobham PRORXB, a Broadcast Receiver/Decoder device.
About
With this connector, you can monitor the Cobham PRORXB receiver/decoder device using SNMP. Generic parameters, receiver parameters and event parameters are displayed.
The bandwidths, lock statuses and power status are polled every 10 seconds. The other parameters are polled every minute.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version | No | No |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | Unknown |
Installation and configuration
Creation
Main connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device, e.g., 10.150.3.3.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device. The default value is public.
- Set community string: The community string used when setting values on the device. The default value is public.
Usage
The connector contains 4 pages.
General
This page displays general information about the device: Power Status, Serial Number, Version Number and Temperature.
Pro RX
This page contains 7 parameters for each of the two receivers: Frequency, Bandwidth, FEC Rate, Lock Status, GPS Valid, GPS Latitude and GPS Longitude. The bandwidths and lock statuses are polled every 10 seconds, along with the Power Status from the General page. The other parameters of this connector are polled every minute.
Event
This page displays all the parameters that are related to events, i.e., the ID, Description, Type, Severity, Time, Root Time, Unit Name, Unit Address, Node Name and Node Value.
Web Interface
On this page, you can view the web interface of the device. However, the client machine has to be able to access the device. Otherwise, it will not be possible to open the web interface.