ComSonics QAM Marker
The ComSonics QAM Marker connector is an HTTP-based connector that can be used to monitor and configure the ComSonics QAM Marker.
The ComSonics QAM Marker generates a non-interfering marker signal that is inserted into downstream cable channels.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version, featuring monitoring and configuration of marker data. | - | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
HTTP Main Connection
This connector uses an HTTP connection and requires the following input during element creation:
HTTP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination. Set to 80 by default.
- Device address: The bus address of the device. Set to BypassProxy by default.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
You can monitor and configure the marker data using the parameters on the General page.
The Network Settings page can be used to monitor the network data. This page contains a subpage Edit Network Settings, which allows you to edit the network configuration using local parameters, saving the values to the device in 1 request. Saving the network settings to the device will cause the device to reboot, which may take some time. This will also cause the marker settings to be lost unless the front panel reset button is pressed or the settings are manually reconfigured.