Table of Contents

Comstream DMD20 SNMP

Through this connector is possible to gather and view information from the device Comstream DMD20SNMP. It also gives the possibility to set values on the device.

About

Connector used to gather information from the Comstream DMD20SNMP device.

The connector has several pages with general information, alarms, information regarding the modulator and the demodulator, etc.

Creation

SNMP

SNMP Connection:

  • IP Address/host: The polling IP of the device.

SNMP Settings:

  • Port number: the port of the connected device, default 161
  • Get community string: the community string in order to read from the device. The default value is public.
  • Set community string: the community string in order to set to the device. The default value is private. Other info

Usage

Main View

This page displays some main info of the device, e.g., summary alarms, voltage alarms, modulator and demodulator general parameters.

General

This page displays some general info of the device, like firmware versions, voltage supply, remote control mode, etc.

This page contains a button to test the reset of the device. It also contains for page buttons where it can be found some general information of several components of the device.

Alarms

This page shows the status of the alarms present on the device.

It also contains the following page buttons:

  • Force Alarms.
  • Mask Alarms.
  • Memorised Alarms.
  • Insert Status.
  • Drop Status.
  • More Demod. Alarms.
  • Normalize alarms.

Modulator

This page display information related to the modulator. Besides displaying information it is also possible to set configurations parameters to the device.

This page contains two page buttons:

  • LBST Settings.
  • More Settings.

Demodulator

This page display information related to the demodulator. Besides displaying information it is also possible to set configurations parameters to the device.

This page contains two page buttons:

  • LBST Settings.
  • Buffer Settings.
  • More Settings.

AUPC

This page shows and gives the possibility to set parameters related to the AUPC.

Save / Load Configuration

In this page is possible to Save to a csv file all parameters values. After, is also possible to Load that same file. It will set the parameters qith the values that were saved.

  • The file will be stored by default on this folder: C:\Skyline DataMiner\Documents\DMA_COMMON_DOCUMENTS\PROTOCOLNAME]

  • The file will be named by default: backup_ELEMENTNAME_datetime

Improve this page