Control By Web X400
The Control By Web X400 is a web-enabled programmable logic controller. The modules in the X-4xx series have various combinations of relays, digital inputs, analog inputs, 1-wire bus (for temperature/humidity monitoring), etc. Most of the modules have a fixed number of I/O; however, the X-400 has a ribbon-cable expansion bus, which allows expansion I/O modules to be directly connected to the X-400, making its I/O customizable.
This connector can only be used to monitor information. Traps received will be used to poll the most recent values.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
HTTP Main Connection
This connector uses an HTTP connection and requires the following input during element creation:
HTTP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination (fixed value: 80).
- Device address: The bus address of the device. If the proxy server has to be bypassed, specify BypassProxy.
SNMP SNMP Connection Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Initialization
Username and Password must be filled in order to retrieve data from the device.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
Once a valid Username and Password have been specified, content is retrieved and shown in the table.
Rows where the Row Status is "Not available" can be deleted automatically if the parameter Removed Not Available Rows is set to Auto, or manually if this parameter is set to Manual (default setting). You can remove a row by clicking the Delete button.