Cross Technologies 2082-14x
This SNMP connector provides an overview of the status of the available amplifiers used by the model 2082-14x series. The connector allows you to manually select the redundancy mode that corresponds with the used model.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Retrieve amplifier data based on configured redundancy mode. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | Rev: 6.00 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Initialization
Select the needed redundancy mode on the Configuration page. Based on this, either amplifier 1 and 2 (redundancy mode 1:1) will be monitored or amplifier 1, 2 and 3 (redundancy mode 1:2).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
On the Config page, configure the Redundancy Mode that is used by the connected unit. This will indicate what module type is expected and retrieve the amplifier data, which will then be displayed on the General page.