Table of Contents

Crosspoint HUB-DSPv2

The Crosspoint HUB-DSPv2 is used to read out and monitor the Multiviewer device.

About

The Crosspoint HUB-DSPv2 is a read-only protocol containing the general and status information from the device. This information is retrieved via an HTTP connection.

Installation and configuration

Creation

This connector uses an HTTP connection and requires the following input during element creation:

HTTP CONNECTION:

  • IP address/host: The polling IP of the device.
  • IP port: The IP port of the device.
  • Bus address: The bus address of the device, by default ByPassProxy.

Usage

General

On the General page, the following information is displayed:

  • General information, with the parameters Serial Number, Version and Device Name.
  • Status information, with the parameters Temperature, Matrix Connection, PS Values, and the Voltages.
  • Basic device information, with parameters such as the Name, Version, Serial Number, Firmware Version, Temperature, Voltage Values, and all alarms for the device.
Improve this page