DEVA Broadcast DB44

The DEVA Broadcast DB44 connector displays information related to the DEVA Broadcast DB44 Receiver device.

About

This connector uses an SNMP connection to communicate with the DEVA Broadcast DB44 device.

Installation and configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP Connection:

• IP Address/host: The polling IP of the device, e.g., 10.145.1.12.

SNMP Settings:

• Port number: The port of the connected device, by default 161.
• Get community string: The community string required to read from the device. The default value is public.
• Set community string: The community string required to set to the device. The default value is public.

Usage

General Page

This page displays status parameters such as the Device ID, IP Address, etc.

Setup Page

This page displays the configurable setup parameters for HTTP, SNMP, etc.

Management Setup Page

This page displays a table with extra configurable parameters for each channel.

Alarm Page

This page displays a table with the active alarms of the device.