Dantherm Flexibox 900
This connector controls the functions of the Dantherm Flexibox 900 device. It can be used to configure cooling, humidity, damper and fan set points and controls, and also allows you to check the status of the device.
About
This connector displays information that is polled from the device with SNMP. Each parameter will be written to the SNMP configuration and must be saved before it is applied to the device.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.1 [SLC Main] | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 1.54a |
Installation and configuration
Creation
SNMP Main connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Usage
General
This page contains general information on the Flexibox device, such as the network connection information and various serial numbers.
It is also possible to access the SNMP Configuration parameters via a page button, as well as High Level Controls such as Cooling/Heater Set Points.
Note: After you configure settings related to the network information, such as Host Name or DHCP State, press the Save Configuration button to accept the changes. The same goes for the SNMP Configuration and other configuration pages.
System Status
This page displays the status of the system. At the top of the page, you can find the System Temperatures. The status of each zone, fan and damper can be found in separate boxes below.
Page buttons provide access to specific Digital Alarms and Controller Alarms.
Cooling Configuration
This page displays the configuration parameters for Fan 1 and Fan 2. After you perform changes on these parameters, press the Save Configuration button to make the device accept the changes.
There are also page buttons leading to configuration parameters for the Heater, Humidity, Air Conditioners and Dampers. After you perform changes, make sure to press the Save Configuration button on the relevant page.
System Configuration
This page displays system configuration parameters, such as the Cooling Mode, Zone Configuration and System Limits. After you perform changes on these parameters, press the Save Configuration button to make the device accept the changes.
The page buttons on this page display configuration parameters for Night Mode, NONC and Xzone. After you perform changes on these parameters, make sure to press the Save Configuration button on the relevant page.
Alarm Configuration
This page displays the Alarm Configurations table, which allows you to configure alarm states and their NO/NC values or alarm delays.
If you modify an alarm state, use the Save Configuration button afterwards to save the changes to the device. If you change an alarm NO/NC or delay, use the Save Delay and NONC button to save the changes to the device.
Web Interface
This page displays the web interface of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.