Digidia FlexiDAB

The Digidia FlexiDAB is a DAB/DAB+/DMB multiplexer with integrated audio and data encoders.

About

This protocol monitors the Digidia FlexiDAB multiplexer over SNMP, with the possibility of receiving traps for the parameters indicating alarms.

Installation and configuration

Creation

SNMP Main Connection

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

• IP address/host: The polling IP of the device, e.g., 10.11.12.13.

SNMP Settings:

• Port number: The port of the connected device, by default 161.
• Get community string: The community string used when reading values from the device, by default public.
• Set community string: The community string used when setting values on the device, by default private.

Usage

General

This page displays basic information about the device. There are two buttons to reset specific information:

• Reset System Configuration
• Reset System Equipment

The Refresh button will poll all SNMP parameters again.

Users

This page displays the device's users and access levels.

Ethernet and Trap Settings

On this page, you can find settings and information regarding the Ethernet cards and SNMP Traps.

Trap Notifications

This page contains the Trap Alarm Notification Table. The time and trap counter are at the top of the page.

Event Log

This page contains the Event Log Table. A button to clear the table is available at the bottom of the page.

Alarm Settings

This page contains the Alarms Bool Settings Table and Alarms Threshold Setting Table.

Alarm Status

This page displays parameters that indicate specific device alarms. When a trap is received, the specific alarm value will be polled again.

Note that since these parameters are statuses, the possible values are OK or Alarm.

Application Notification

This page contains the Application Alarm Notification Table.

Alarm History

This page contains the Global Alarm Table.