Double D Electronics DDA70-80

This connector can be used to display and configure information of the Double D Electronics DDA70-80 WG Switch.

About

This protocol uses a serial connection to monitor and control the Double D Electronics DDA70-80.

Installation and configuration

Creation

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

• IP address/host: The polling IP of the device, e.g., 10.11.12.13.
• TCP: Connection is selected automatically.
• Port: The port to connect to the device.
• Local Port: The local IP port to be used, e.g., 8000.
• Bus Address: The bus address of the device. The default value is 65.

Usage

General Page

This page contains generic device information, such as the Software Version, Device Name and General Alarms.

When commands are sent to the device, the response status (error/ok) is displayed on this page. The button Acknowledge can be used to clear this status.

Switches Page

On this page, you can monitor and configure the status and positions of the switches.

Chains Page

On this page, you can see the status of the chains on the device.