Double D Electronics DDA70-87
This connector can be used to display and configure information of the Double D Electronics DDA70-87 WG Switch.
About
This protocol uses a serial connection to monitor and control the Double D Electronics DDA70-87.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | V2.65f 18.07.05 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
This connector uses a serial connection and requires the following input during element creation:
Serial Connection - Main
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Direct connection:
- Baudrate: Baudrate specified in the manual of the device, default 9600. Range from: 1200, to: 115200.
- Databits: Databits specified in the manual of the device, default 7.
- Stopbits: Stopbits specified in the manual of the device, default 1.
- Parity: Parity specified in the manual of the device, default even.
- FlowControl: FlowControl specified in the manual of the device, default No.
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
- Bus address: The bus address of the device.
How to Use
General Page
This page contains generic device information, such as the Software Version, Device Name and General Alarms.
When commands are sent to the device, the response status (error/ok) is displayed on this page. The button Acknowledge can be used to clear this status.
Switches Page
On this page, you can monitor and configure the status and positions of the switches.
Chains Page
On this page, you can see the status of the chains on the device.