EATON ATS
The EATON ATS is a device that can automatically switch between two power sources to provide uninterrupted power to connected equipment.
It is typically used to add power redundancy to networking equipment, such as switches and routers.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 00.00.0012 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
The connector also uses traps to receive alarm status updates.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The element displays the available information of the device on the following pages: General, Input, Output, Bypass, Alarms, and Sensors.
On the Polling page, you can configure the polling of the parameters.