EF Data Comtech LBC-4000

The EF Data Comtech LBC-4000 connector can be used for displaying and configuring information of the EF Data Comtech LBC-4000 device.

About

This protocol can be used to monitor and control the EF Data Comtech LBC-4000 device. The connector supports one serial connection to communicate with the device.

The protocol also has alarming and trending.

Installation and configuration

Creation

SERIAL

SERIAL Connection:

• IP address/host: the polling IP or URL of the destination e.g. 10.15.1.80
• IP port: the port of the destination e.g. 4003.
• Bus address: this field is not necessary to be filled.

Usage

Main View

This page displays some general info of the device. E.g.:

• Equipment Type
• Date
• Redundancy Mode
• Etc.

Configuration Page

This page displays the device configurations. E.g.:

• Remote Mode
• Fault Relay Logic
• Firmware Image Selection
• Etc.

Convert A Page

This page displays and allows to configure the Converter A.

Convert B Page

This page displays and allows to configure the Converter B.