ETI ADH NETCOM

The ETI ADH NETCOM is an Automatic Air Dehydrator that uses Ethernet communication. It prevents the accumulation of moisture in transmission lines by maintaining the pressure and dew point of the air inside the line.

About

This connector is used in order to gather information from the device, such as alarms and measurements.

Installation and configuration

Creation

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

• Type of Port: UDP/IP
• IP address/host: The polling IP of the device.
• IP port: The IP port of the device, 52091.
• Bus address: Not used.

Usage

General

This page shows information related to:

• Control: Allows you to set the dehydrator into standby or online mode.
• ADH NETCOM Identification: Displays information related to the unit.
• Dehydrator Status Information: Displays the current status and state of the unit.
• Measurements: Displays current measurements.
• From Master To Slave: Used when the dehydrator works as a Master in a serial master-slave connection between two dehydrators.

Alarms

This page displays the current state of the dehydrator's alarm relays.

Notes

The ADH NETCOM automatic dehydrator receives commands on UDP port 52091. When it is operating as a master dehydrator in a master/slave configuration, the master will send out messages using UDP port 52092 as the source port and 52091 as the destination port.