ETL Systems 22302

L-band splitter. Modular system chassis for matrix systems that holds up to 32 hot-swap splitter modules and also benefits from dual redundant power supplies and CPU module.

About

This connector requests System, CPU, PSU and Module information from the device. It is possible to configure the traps and RF Detector Settings.

Installation and configuration

Creation

SNMP connection

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

• IP address/host: The polling IP of the device.

SNMP Settings:

• Port number: The port of the connected device, by default 161.
• Get community string: The community string used when reading values from the device, i.e., public.
• Set community string: The community string used when setting values on the device, i.e., private.

Usage

General

This page contains System and CPU parameters and a PSU Readings table.

Module Info

This page contains a Module Info table. For every module in the chassis, there is a row in the table that contains more detailed information, such as Summary info, Firmware info, status for PSUs and Amplifiers ...

Configuration

This page contains Configuration data for traps and for the RF Detector.

Web Interface

Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.