ETL Systems 22433

The ETL Systems 22433 is an L-band hybrid splitter and combiner shelf designed to power and reference VSAT terminals, as well as facilitate the use of multiple modems.

This connector can be used to monitor and control the device via SNMP. The connector layout is designed to be as similar as possible to the web interface of the device.

About

Version Info

Range	Key Features	Based on	System Impact
1.0.0.x [SLC Main]	Initial version	-	-

Product Info

Range	Supported Firmware
1.0.0.x	-

System Info

Range	DCF Integration	Cassandra Compliant	Linked Components	Exported Components
1.0.0.x	Yes	Yes	-	-

Configuration

Connections

SNMP Main connection

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

• IP address/host: The polling IP of the device.

SNMP Settings:

• Port number: The port of the connected device, by default 161.
• Get community string: The community string used when reading values from the device (default value: public).
• Set community string: The community string used when setting values on the device (default value: private).

Web Interface

The web interface is only accessible when the client machine has network access to the product

How to use

The element created with this connector consists of the following data pages:

• General: This page displays information on the Module Status, Supply Voltages and Currents. It contains for example the LNB Status, 24V BUC Status, TX/RX Amplifier and 18V PSU1 Status.
• Configurations: On this page, you can configure settings such as the Polling time, RF Power Limits and Traps IP Destination address, as well as enable or disable traps on the device.
• Web Interface: This page provides access to the web interface of the device. However, note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.