ETL Systems 2771
This connector is used to monitor an ETL Systems 2771 device.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 1.0 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Direct connection:
- Baudrate: Baudrate specified in the manual of the device, e.g., 9600.
- Databits: Databits specified in the manual of the device, e.g., 7.
- Stopbits: Stopbits specified in the manual of the device, e.g., 1.
- Parity: Parity specified in the manual of the device, e.g., No.
- FlowControl: FlowControl specified in the manual of the device, e.g., No.
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
- Bus address: The bus address of the device. By default, 66.
How to Use
This connector contains the following pages:
- General: Displays general information about the device such as the Version and IP Address, as well as some monitored values of the chassis such as Temperature, PSU Voltage, etc.
- Control: Displays the current and voltage measured by the device.