Electrosys G011 FM N+1
The Electrosys G011 FM N+1 can be used to monitor transmitters via a transmitter controller. This connector uses SNMP to connect to the transmitter controller.
For each monitored transmitter, a DVE can be created.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | Electrosys G011 FM N+1 - Main Transmitter Electrosys G011 FM N+1 - Reserve Transmitter |
Configuration
Connections
SNMP Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device (default value: public).
- Set community string: The community string used when setting values on the device (default value: private).
Initialization
This protocol supports both MIB versions, which have slightly different OIDs. In some cases *.1.* is used, while in the other cases *.255.* is used in the OID. The connector will automatically try and select the correct OID when a new element is created.
First it will try to poll a parameter using the *.1.* OID. If this fails, it will switch to *.255.*. If both fail, by default, the connector will only retry further with *.255.*. However, you can configure this using the Device OID parameter on the General page.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How To Use
The element consists of the following data pages:
General: Contains general system information and system commands.
Main Transmitters: Shows information for all the main transmitters installed on the machine. Also contains a page button to the Main DVE page.
Main DVE Page: Shows the DVE table for the main transmitters. You can enable or disable all DVEs for the main transmitters here.
Reserve Transmitters: Shows information for the reserve transmitters installed on the machine. Also contains a page button to the Reserve DVE page.
Reserve DVE Page: Shows the DVE table for the reserve transmitters. You can enable or disable all DVEs for the reserve transmitters here.