Emcore Medallion 8100
The Emcore Medallion 8100 series is a family of high-performance DOCSIS 3.1 compliant 1550 nm externally-modulated CATV transmitters.
About
This connector is used to monitor and configure the Emcore Medallion 8100. It uses an SNMP connection to get/set data from/to the device.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 1.20 |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Usage
General
This page shows general information regarding the device: Tag ID, Device Type and Serial Number.
Page buttons provide access to the following subpages:
- Front Panel LED: Displays the LED status information.
- Network Config: Allows you to view and configure the network information, IP Address, Gateway, Netmask and IP Mode.
Transmitter Data
This page allows you to view and edit the transmitter parameters, such as CATV RF Input, CATV Composite RF Level, CATV Attenuation and System Temperature.
Power Supply
This page contains power supply information, such as the Power Supply Type, Temperature and Status.
Web Interface
This page displays the web interface of the device. Note that the client machine has to be able to access the device, as otherwise, it will not be possible to open the web interface.