Emcore Optiva NMS - Transmitter
The Emcore Optiva NMS - Transmitter connector is a DVE child connector that makes it possible to retrieve information from a transmitter and to control its behavior.
About
This connector uses SNMP polling to communicate with the device.
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.1.x | 1.1 |
Installation and configuration
Creation
This connector is used by DVE child elements that are automatically created by the connector Emcore Optiva NMS, from version 1.0.1.1 onwards.
Usage
General
This page displays specific information for each transmission card. It also contains the following buttons:
- +0.5 dB/-1dB: With these two buttons, you can adjust the RF Gain with +0.5 dB or -1 dB, respectively.
- Activate: This button is used to activate TX Peak Performance, which changes RF gain so that the RF power at the laser is approximately at a value for peak (optimum) performance.