Enensys GigaCaster DMB
The Enensys GigaCaster DMB is a DAB/DAB+/DMB multiplexer with audio and data encoders.
About
This connector monitors and configures Enensys GigaCaster DMB devices over SNMP, with the possibility of receiving traps on alarm updates.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version. | - | - |
| 1.0.1.x [SLC Main] | Compliancies, version history, and new parameters have been added in this version. | 1.0.0.3 | Page name changed. Cassandra compliance added. |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | No | - | - |
| 1.0.1.x | No | Yes | - | - |
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device, e.g., 10.11.12.13.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The element created with this connector consists of the data pages described below.
General
This page contains information about the device itself:
- Identification, e.g., Device Name, Device Type, Device Serial Number, etc.
- Hardware status, e.g., Product Mode, Current Temperature, etc.
- Generic alarm information: Current Status, Alarm Current Count.
- Date and time: Date Time ISO, Date Time Unix.
- Options: Device Option Table.
The page also allows you to restart the multiplexer with the Reboot Device button, or to reset it by entering confirm in the Device Factory Reset box. You can also have all parameters polled again with the button Refresh all Values.
IP to ETI
This page contains a Config and Stats table to monitor and configure the processing for the direction IP to ETI.
ETI to IP
This page contains a Config and Stats table to monitor and configure the processing for the direction ETI to IP.
Alarms
On this page, you can monitor the current alarms and their history, in the Alarm Current Table and the Log Table respectively.
Alarm Settings
On this page, you can configure each alarm individually in the Alarm Table. The Trap V2 Destination Table contains the SNMP trap configuration.
Interface
On this page, you can configure each interface of the device in the Information Table.