Enensys T2-Mi Gen
T2-MIGen is ENENSYS's T2-MI generator for local headends managing few TV services. It can encapsulate one or two transport streams stemming from a multiplexer or directly from encoders into a T2-MI stream. It outputs the resulting T2-base or T2-lite compliant multiplex through ASI and IP.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 1.2.1 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination (default: 161).
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
On the General page, you can find general configurable system information such as the Name, Type, Location, and Update URL, and whether SNMP Polling is enabled for this page. The Identify button on this page can be used to make an LED blink on the front panel of the device in order to easily identify it.
On the Polling configuration page, you can configure whether polling should be enabled for specific pages.
Since version 1.0.0.2 of the connector, you can remove alarms with severity "No Log" from the Alarm Current table by setting the No Log Entries Displayed toggle button to No.