Enensys TxEdge-OneBeam
TxEdge-OneBeam is an ENENSYS solution designed to reduce satellite OPEX costs by delivering Direct-To-Home (DTH) TV and Digital Terrestrial TV (DTT) distribution over one satellite feed that supports DVB-T/T2 and DVB-S/S2 standards.
This connector uses SNMP to poll information from the TxEdge-OneBeam device.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 4.1.3 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
- Bus address: The bus address of the device.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
On the General page, you can find status and configuration parameters related to the device.
On the Network page, several tables are available:
- The Network Interfaces Table allows you to configure the IP addresses and contains different settings related to each interface.
- The IP Configuration Table allows you to select the state, ports, destination IPs etc. for each IP input/output.
- The IP Statistics Table displays information about the bit rate, jitter, etc.
The TS Display page contains transport stream and service information.
The Satellite page contains input 1 and 2 status parameters such as RF Level, BER and Symbol Rate. You can also configure parameters such as DVB Mode, Satellite Frequency, LNB Frequency, etc.
The Headend page contains status parameters related to ASI 1, 2 and 4, such as the bit rates. It also displays bit rates related to layer 1 to 7. Finally, it also allows you to configure the Product Mode, Main Source and Backup Source for the input.