Envivio Halo Redundancy

About

The Envivio Halo Redundancy connector will retrieve a list of configured Envivio Halo elements in the DMS. You can then subscribe to maximum 2 of those elements to receive the alarm status. When both of the configured elements have the same alarm, the redundancy element will also show the alarm in the Alarm table.

Creation

This connector uses a virtual connection and does not require any input during element creation.

Timing

Every hour, the list of configured Envivio Halo elements will be updated.

Every 5 minutes, the connector checks if the elements are active or not and cleans alarm entries if needed.

Usage

The element contains 5 pages:

Redundancy Config: Provides an overview of all the installed Envivio Halo elements that are using the "production" version. Using the Registration button, it is possible to enable or disable the registration on the alarms table of maximum 2 elements.
Services/Outputs/Recording: These pages are currently not used yet.
Alarms: This page provides a summary alarm overview of the configured Envivio Halo elements. When the same alarms are active on both devices, these will also be shown in the alarm table for the Halo Redundancy.

Latest Version