Ericsson AVP-3000
The Ericsson AVP-3000 connector is a HTTP connector that is used for monitoring Advanced Video Processor configuration.
About
With this HTTP Advanced Video Processor connector you can control the configuration if nothing goes wrong, change the configuration where possible and even restore the configuration if needed.
Ranges of the connector
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.1.x [SLC Main] | Initial version | Yes | False |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.1.x | Unknown |
Installation and configuration
The Ericsson AVP-3000 connector has a HTTP Connection:
- Port: 80
- Bus address: ByPassProxy (if it need to pass a proxy server)
- IP Address: The IP of the Device
Creation
HTTP Main Connection
This connector uses a HTTP connection and requires the following input during element creation:
HTTP CONNECTION:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
- (default: ByPassProxy)
Configuration
On the General Page, there is a Page Button Credentials... On the Credentials page, enter the User Name and Password that are used for the HTTP Communication.
Usage
General
On this page you have an overview of the Device Information and all possible Slots.
Stored Configurations
Here you see the Last Loaded Configuration, this is possible to change when you want to restore a configuration with one of the possibilities from the table.
ASI Output 1 & 2
Satellite Modulator - Output
Here you have a nice overview from all Satellite Modulator Output parameters. The left Output group shows you the basic output parameters, if you change the Output Select you will see that the right Output group, L-Band Output group and the IF Output group parameters change.
The right Output group shows all general parameters of L-Band Output group and IF Output group.
The parameters that are "NA" (Not Available) are disabled because they aren't requested.
Satellite Modulator - Modulation
Here you have a nice overview from all Satellite Modulator Modulation parameters with the possibility to make changes to them.
Satellite Modulator - Input
Here you have a nice overview from all Satellite Modulator Input parameters with the possibility to make changes to them.
Transport Stream
Here you have a nice overview from all Transport Stream parameters with the possibility to make changes to them.
Service
Video Component - Input
This page shows us everything about the Video Component Input, here we can see and change the settings we want.
Video Component - Output
This page shows us everything about the Video Component Output, here we can see and change the settings we want.
Video Component - Encode
This page shows us everything about the Video Component Encode, here we can see and change the settings we want.
Video Component - VBI
This page shows us everything about the Video Component VBI, here we can see and change the settings we want.
Audio Component - Input
This page shows us everything about the Audio Component Input, here we can see and change the settings we want.
Audio Component - Encode
This page shows us everything about the Audio Component Encode, here we can see and change the settings we want.
Alarms
A page for the overview of all Active Alarms at the bottom you see page buttons which open a page with an overview of the Alarms of that specific slot. Standard the connector doesn't poll for these alarms so the bandwidth that the connector use will increase a lot.
Slot Configuration
Here we made it possible that you can choose on which slot you would like to poll for the Video Component (standard 3) and the Satellite Modulator (standard 6).
Notes
When you change the Last Loaded Configuration it take some few seconds when the change happens, this is because the connector waits until the restore of the configuration is done and after that he refresh all the parameters.