Ericsson TT1222
This is an HTTP connector that is used to retrieve status information from the Ericsson TT1222, an integrator receiver decoder (IRD) device.
About
The information on tables and parameters is retrieved via HTTP polling.
This connector contains an overview of the active alarms, modules, Service System, Service TV (which includes TV Service, Video and Audio 1), Service Audio 2 and Output Status.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 1.0 |
Installation and configuration
Creation
HTTP Main Connection
This connector uses an HTTP connection and requires the following input during element creation:
HTTP CONNECTION:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
- Device address: The device address, by default ByPassProxy.
Usage
General
This page displays general information about the device, such as the Device Info, IP Address, Current Status, Current Time, Input Status, Video Status, Audio 1 Status and Audio 2 Status.
Alarms
This page displays the Alarms Table.
Device Info
This page displays all the parameters related to Product Information (Name, Product Name and Product Version) and Alarm Information.
In the Product Information section, three page buttons display the Network Settings, the Modules table and the Remote Configuration.
In the Alarm Information section, two page buttons display the Alarm Filters and Alarm Types tables.
Presets
This page displays preset selection and saved preset information.
Input
This page displays the parameters related to TS Input Status, RF Input Status and RF Input Control.
Service - System
This page displays the PSI Mode, System Delay, Data Parameters and Data Port Settings.
Service - TV
This page displays the TV service ID, as well as Video and Audio 1 related parameters.
It also includes the page buttons Teletext - Subtitles, DVB - Subtitles, TV Service PIDs, Service Cycling, Video Advanced and Audio 1 Advanced.
Service - Audio 2
This page contains parameters related to Audio 2. More advanced parameters are available via the page button Audio 2 Advanced.
Conditional Access
This page contains CA-related parameters.
Output
This page displays parameters related to the output streaming.
The GPO or General Purposes Output page button displays the triggering information coming from events No Input Lock, Video Error, Audio 1 Error, Audio 2 Error, Data Error and BER Exceeded.
Web Interface
This page provides access to the web interface of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.