Evertz 3480TSM
This connector is used to monitor the Evertz 3480TSM transport stream monitor.
About
This connector uses an SNMP connection to collect traps from the device. The status information of the monitored parameters is updated based on the collected traps, and the traps information is stored in a local database.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version for traps implementation. | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | Unknown |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- IP port: The IP port of the device.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Usage
Traps
This page contains the general Traps Table as well as a number of parameters related to this table. There is also a button that can be used to enable or disable storing the traps in the local database, and a configurable parameter with the IP from which traps are obtained.
Traps Advanced Search
This page can be used for the advanced search of traps stored in the local database. It allows you to configure a number of filters to limit the search results.
Ethernet Link
This page contains the Ethernet Link Faults table, with information about the status of the Ethernet interfaces.
Power Supply
This table contains the Power Supply Status table, with information about the status of the power supplies.
Input Faults
This page contains the Input Faults table, with information about the status of all the parameters related to the differents inputs.