Evertz 5700ACO
This connector is used to monitor and control the Evertz 5700ACO device.
The 5700ACO automatic changeovers are intended for use with two 5700MSC master clock/sync generators. The 5700ACO system uses mechanically latching relays to ensure maximum reliability and minimal disruption in the event of any failure, even power failures.
The changeover uses a voting system based on which source has the best signals and on whether the good signals on the current master are also present on the backup master.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | - Manual/automatic changeover - Voting configuration |
- | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 2.0 47 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The connector has two main pages, the General page and the Control page.
- The General page contains device status parameters, such as Firmware Version and Operation Mode.
- The Control page is used to change the device configuration. You can for example configure the voting process and change the Control Status to manual/automatic.