Evertz 5700MSC
The 5700MSC-IP is an IP Network Grand Master Clock and a Video Master Sync Generator both referenced to GPS and/or GLONASS. The system features 2x GbE, 2x10 GbE ports, 6x fully timeable sync outputs, 4x SDI outputs and a loop-thru reference input.
This connector displays the status and controls of the generators and system information.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version. | - | - |
| 1.1.0.x | Trap/Syslog Table implementation; various display key and parameter description changes. | - | - |
| 1.1.1.x [SLC Main] | Changes to various display discrete values and position of columns. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 1.0 1289 |
| 1.1.0.x | 1.0 1286 |
| 1.1.1.x | 1.0 1286 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
| 1.1.0.x | No | Yes | - | - |
| 1.1.1.x | No | Yes | - | - |
Configuration
Connections
SNMP Connection - Main
This connector uses a Simple Network Management Protocol (SNMP) connection to communicate with the device, and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The IP of the Evertz device.
- IP port: The IP port of the destination, by default 161.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The element consists of the data pages detailed below.
General
Contains the general device configuration, including the GPS State, Glonass, Leap Time, and GPO 1 and 2.
Status
Displays device status parameters, including the PTP State table.
Reference Control
Contains the configuration parameters for the reference controls, including the Frequency, Time and VITC Line Time References.
At the bottom of the page, you can find the IP Servers table.
Sync Controls
Contains the Sync Information table, which can be used to configure the syncing of the device.
Global
Contains global configuration parameters, primarily the GPS, Video, 10 MHz, Free Run, and Payload Type configuration.
PTP Controls
Contains PTP controls. The PTP Engines table contains the engines configuration, while the Acceptable Masters table contains the configuration of acceptable master devices.
Via a page button, you can configure and view the PTP Faults table.
NTP General
Contains the Spoofing Control and NTP Information table.
TG Control
Allows you to configure the test generators. The main page includes the Test Generator Controls table and Test Generator IP Table, while the TG Audio Controls are available via a page button.
LTC Control
Displays the LTC Controls table.
Analog Audio
Allows you to configure the Level Left, Level Right, Frequency Left, and Frequency Right.
At the bottom of the page, you can find the Analog Audio Events table.
AES DARS
Contains the DARS/AES configuration parameters, including the Fine and Coarse Phase, as well as the Channel 1-3 Frequency and Levels.
Control and MGM Faults
Contains a table listing the Control Faults and MGM Faults.