Evertz 7703BPX-DC-RF
The 7703BPX-DC-RF is a 2x1 RF protection switch for a wide range of frequencies. It provides automatic changeover functionality to provide bypass protection of RF signals from 1-2250 MHz, and for DC LNB bias. The 7703BPX-DC-RF has integrated technology for remote control and monitoring capability via SNMP.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 1.3.46 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
How to use
The General page contains basic status parameters for the device.
The frame controller supports more modules fitted in the chassis. The connector will display these as instances. The names of the added card types can be found in the Monitor Table on the Control page.
For each of those modules, you can configure the input in the Input Control Table on the Control page. The connector handles the switching logic taking into account the fact that different cards supported by the connector (SWRF16B7703, SWRF8B7703, SWRF47703) have a different number of inputs available (16, 8, 4, respectively).