Evertz 7800SW-GE
This connector displays general information about the Evertz 7800SW-GE and allows you to monitor the input and output ports.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | N/A |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
- Bus address: The bus address of the device.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
How to use
The element created with this connector has the following data pages:
- General: Displays general information about the device such as the Firmware and Serial Number. Also contains the System Control table, which allows you to reboot the system or perform a factory reset.
- VLAN Configuration: Displays the VLAN State and related information, as well as the VLAN Ingress and VLAN Egress tables.
- Port Monitoring: Displays statistics regarding the input and output ports, such as Good Frames, Dropped Packets, Discarded Packets, etc.