Evertz 7880DM4-LB-IP - 7880DM4-LB-IP
This connector is used to monitor and control the Evertz 7880DM4-LB-IP card. The Evertz 7880DM4-LB-IP is used to demodulate digital terrestrial ATSC/8VSB/ ISDB-Tb, QAM/ DVBC/ DVB-C2 cable signals, DTV signals or digital DVB-S/S2 satellite signals.
About
Both an SNMP and HTTP connection are used in order to successfully retrieve and configure the information of the device. There are also different possibilities available for alarm monitoring and trending.
This connector is automatically generated by the connector Evertz 7880DM4-LB-IP.
Product Info
| Connector Version | Device Revision |
|---|---|
| 1.0.0.1 | 2.0.109 |
Installation and configuration
Creation
This connector is used by DVEs that are automatically created by the parent element. No user input is required.
Usage
General
This page contains general information about the status of the cards in the frame controller, including Status, Frame Slot, Name and Display information.
System
The information on this page is divided over several sections. This includes the System parameters, Data Port parameters, System Preset Table, Serial Number, and System Product Feature Table.
Input
This page contains the Control Demod Tables 1 and 2, which allow you to manage and control the Demod parameters.
IP Input Control
This page provides access to the IP input Controls. It allows you to enable or disable the Stream and set the Receive Mode, MultiCast IP, UDP Port, RTP Protocol, IGMP enable, Status Clear and IGMPV3 Mode.
IGMPV3 SSM Source IPs 1 through 6 can also be found on this page.
TS Input
This page contains the ASI Control Table as well as TS Input Table 1 and 2. These tables contain all TS input controls.
Output
This page contains four tables that are linked together. The first is the Output Stream Table, which provides the controls for each specific output. Each output has a corresponding stream, for which all related controls can be found in the table. This same functionality can be found in the other three tables: the Service Filter Ctrl Table, Service Filter Program Table and Service Filter PID Table.
Traps
This page contains the Demod Fault Table. This table provides the controls to enable or disable Demod traps for a given RF input. If a trap is present, the fault will be displayed as present in the Fault table.