Table of Contents

Evertz 7891MG - Card

This connector is used to monitor an Evertz 7891MG card. The 7890MG card is a media gateway.

About

An SNMP connection is used in order to successfully retrieve and configure the information of the device. There are also different possibilities available for alarm monitoring and trending.

This connector is automatically generated by the connector Evertz 7891MG.

Product Info

Range Supported Firmware Version
1.0.0.x 1.5 Build 81

Installation and configuration

Creation

The element using this connector is automatically exported from the Evertz 7891MG connector. The configuration of the element must be done in this parent connector.

The default name of the element is 7890MG2.x, where x is the slot where the card is attached.

Usage

General

This page displays the Card Status, Frame Slot and Card Name.

System

This page displays card information, such as the Card Type, the Firmware Version, the Serial number, the Temperature and the Status of the board.

Access Port

This page contains the following tables:

  • SFP Table: Contains the parameters SFP Name, SFP Media Support and SFP Present.
  • Control Table: Contains the parameters IP, net mask, Gateway, Source UDP and Mode IP.
  • Ethernet Rx Table: Contains the parameters Data Rate, Good Frames, Fragmented Frames, Error Frames, Broadcast Frames, Multicast Frames, VLAN Tagged Frames and Pause Frames.
  • Ethernet Tx Table: Contains the parameters Data Rate, Good Frames, Broadcast Frames, Multicast Frames, VLAN Tagged Frames and Pause Frames.

Trunk Port

This page contains the following tables:

  • SFP Table: Contains the parameters SFP Name, SFP Present, Rx Optical Power, Rx Power Threshold, Tx Wave Length, Ethernet Link Status and Ethernet Link Speed.
  • Control Table: Contains the parameters IP, netmask, Gateway, Source UDP and Mode Select, Bandwidth High Threshold and Sever Error Threshold.
  • Ethernet Rx Table: Contains the parameters Data Rate, Good Frames, Fragmented Frames, Error Frames, Broadcast Frames, Multicast Frames, VLAN Tagged Frames and Pause Frames.
  • Ethernet Tx Table: Contains the parameters Data Rate, Good Frames, Broadcast Frames, Multicast Frames, VLAN Tagged Frames and Pause Frames.

Access to Trunk

This page contains the following tables:

  • Stream Control Table: Contains the parameters Tx Stream Enable, Tx Stream IP Trunk A-B, Tx Stream UDP Trunk A-B, Tx Stream Type, Tx Stream Rate Limit and Tx Stream Port Map.
  • NAT Control Table: Contains the parameters Input IP, Input Mode, IGMP Enable, IGMPv3 and IGMPv3 Source 1-6.
  • Status Table: Contains the parameters Tx Stream Present, Tx Stream Data Rate, IP Input Mode, IP Input RTP Type and IP Input Packet Size.

Trunk to Access

This page contains the following tables:

  • Control Table: Contains the parameters Rx Stream Enable, Rx Stream IP Trunk A-B, Rx Stream UDP Trunk A-B, Rx Stream Mode, Rx Stream Type, Rx Stream Rate Limit, Rx Stream Port Map and Protection Depth.
  • Control IGMP Table: Contains the parameters Rx IGMP Enable Trunk A-B, Rx IGMPv3 Mode Trunk A-B and Rx IGMPv3 Source 1-6 Trunk A-B.
  • Control NAT Table: Contains the parameters Output IP and Output UDP.
  • Status Table: Contains the parameters Rx Stream Present Trunk A-B, Rx Stream Data Rate, Rx Stream Mode, Rx Stream Packet Size, Rx Stream Lost Packets, Rx Stream Protected Packets, Rx Stream Unprotected Packets and Stat Clear.

Notification

This page contains the following tables, which each contain the parameters Fault and Status:

  • Access Port Fault Present Table
  • Trunk Port Fault Present Table
  • Video Decap Fault Present Table
  • Video Encap Fault Present Table
  • System Status Fault Present Table

Notes

These are the current traps implemented in the connector:

  • Traps with ID between 1000 and 1139 update the Access Port Faults Table (PID 4500).

  • Temperature OK/High on Ports 1-10

    • Rx Optical Power OK/Low on Ports 1-10
    • Ethernet Link Up/Down on Ports 1-10
    • Ethernet Data Rx OK/Over on Ports 1-10
    • SFP Present Present/Absent on Ports 1-10
    • Video In Present/Absent on Ports 1-10
    • Video Out Present/Absent on Ports 1-10

  • Traps with ID between 1400 and 1427 update the Trunk Port Fault Table (PID 4600).

  • SFP Temperature OK/High on Trunks A, B

    • SFP Rx Optical Power OK/High on Trunks A, B
    • Ethernet Link Up/Down on Trunks A, B
    • Rx Error OK/Error on Trunks A, B
    • Rx Sever Error OK/Error on Trunks A, B
    • Data Rate OK on Trunks A, B
    • Present Present/Absent on Trunks A, B

  • Traps with ID between 1648 and 1667 update the Video Encap Fault Table (PID 4700).

  • Stream Present Present/Absent on Ports 1-10

    • Stream Present Present/Absent on Ports 1-10

  • Traps with ID between 1668 and 1707 update the Video Decap Fault Table (PID 4800).

  • Stream Present Present/Absent on Ports 1-10 Trunk A, B

  • Traps with ID between 1708 and 1713 update the System Fault Table (PID 4900).

  • Board Fan Present/Absent

    • Board Temperature OK/High
    • Rear Plate Fan Present/Absent
Improve this page