Evertz 7x00 General Platform - 7880IPG-ASI8-IP10GE2

Important

Two versions of this connector are registered, an SNMP version and an HTTP version. The SNMP version was never completed as the client abandoned this connector effort before it was finished. While most of the code has been written, it has not yet been reviewed in any way. As such, thorough testing with a 7880IPG-ASI-IP10GE2 encoder card is required before the SNMP version of this connector can be implemented.

About

This connector is used to monitor and control the Evertz 7880IPG-ASI-IP10GE2 card. The Evertz 7880IPG-ASI-IP10GE2 is a media gateway SDI interface with access points for next-generation hybrid baseband/IP broadcast infrastructures.

An SNMP connection is used in order to successfully retrieve and configure the information of the device. There are also different possibilities available for alarm monitoring and trending.

This connector is automatically generated by the connector Evertz 7x00 General Platform.

Configuration

This connector is used by DVEs that are automatically created by the parent element. No user input is required.

How to Use

General

This page contains general information about the card status in the frame controller. This includes Status, Frame Slot, Name, and Display information.

System

This page contains all system controls and tables. It displays the Data Port Configuration Table, Data Port Monitor Table, and the Time Reference Table 2.

It also allows you to trigger the Load Factory Settings, Reboot, and Sync Now system functions.

Configuration

This page contains all Configuration Tables related to the 7880IPG-ASI8-IP10GE2 card, including the Input Status, VLAN Tagging, and IPG configuration tables 1 to 3.

Product Features

This page displays the product Serial Number and the MAC Address.

System Faults

At the top of this page, you can find the standalone fault for Temperature Overheat. The page also contains three other fault tables, i.e., the Frame Faults Table, Over BW Faults Table, and Trap Faults Table. All controls are the same in that you can enable or disable a particular trap with the Send Trap control for any of the faults. If a fault is present on a certain parameter, it is displayed in the Fault present column.