Evertz 7x00 General Platform - 7890MG

About

This connector is used to monitor an Evertz 7890MG card. The 7890MG card is a Media Gateway.

This connector is automatically generated by the connector Evertz 7x00 General Platform. It allows SNMP traps to update alarm tables.

Configuration

The element using this connector is automatically exported from the Evertz 7x00 General Platform connector. The configuration of the element must be done in this parent connector.

The default name of the element is 7890MG.x, where x is the slot where the card is attached.

How to Use

General

This page mainly displays Card information, such as the Card Type, Firmware Version, Up Time and Temperature. For users with security level 1, it is possible to do a Card Reset.

Input

This page displays the input tables for monitoring, controlling, and alarms.

Output

This page displays the output tables for monitoring, controlling, and alarms.

Trunk Port

This page displays the Ethernet Trunk tables for monitoring, controlling, and alarms.

IP Stream

This page displays the IP stream tables for Input Streams and Output Streams.

SFP Monitor

This page displays the SFP monitor tables for the monitoring of all ports and trunks, and the SFP Alarms.

Trap Configuration

This page allows you to set which traps can be generated by the frame controller for the current card. For each alarm, the Send Trap parameter allows you to enable/disable traps for that fault.

Alarm Tables and Traps

Table cell values for input alarms, output alarms, Ethernet alarms and SFP alarms are refreshed by polling, but they are also refreshed whenever a trap is received.

A trap can be directly logged into the database if the Log Traps column is enabled in the Input Cards table. For the 7890MG, all trap fields will be filled in, along with the description and severity fields.