Table of Contents

Evertz 7x00 General Platform - 7891MG-10GE2

About

This connector is used to monitor an Evertz 7891MG-GE2 card. The 7890MG card is a media gateway.

This connector is automatically generated by the connector Evertz 7x00 General Platform.

Product Info

Range Supported Firmware Version
1.0.2.x 1.5 Build 81

Configuration

The element using this connector is automatically exported from the Evertz 7x00 General Platform connector. The configuration of the element must be done in this parent connector.

The default name of the element is 7891MG.x, where x is the slot where the card is attached.

How to Use

General

This page displays the Card Status, Frame Slot and Card Name.

System

This page displays card information, such as the Card Type, the Firmware Version, the Serial number, the Temperature and the Status of the board.

Access Port

This page contains the following tables:

  • SFP Table: Contains the parameters SFP Name, SFP Media Support and SFP Present.
  • Control Table: Contains the parameters IP, net mask, Gateway, Source UDP and Mode IP.
  • Ethernet Rx Table: Contains the parameters Data Rate, Good Frames, Fragmented Frames, Error Frames, Broadcast Frames, Multicast Frames, VLAN Tagged Frames, and Pause Frames.
  • Ethernet Tx Table: Contains the parameters Data Rate, Good Frames, Broadcast Frames, Multicast Frames, VLAN Tagged Frames, and Pause Frames.

Trunk Port

This page contains the following tables:

  • SFP Table: Contains the parameters SFP Name, SFP Present, Rx Optical Power, Rx Power Threshold, Tx Wave Length, Ethernet Link Status, and Ethernet Link Speed.
  • Control Table: Contains the parameters IP, netmask, Gateway, Source UDP and Mode Select, Bandwidth High Threshold, and Sever Error Threshold.
  • Ethernet Rx Table: Contains the parameters Data Rate, Good Frames, Fragmented Frames, Error Frames, Broadcast Frames, Multicast Frames, VLAN Tagged Frames and Pause Frames.
  • Ethernet Tx Table: Contains the parameters Data Rate, Good Frames, Broadcast Frames, Multicast Frames, VLAN Tagged Frames, and Pause Frames.

Access to Trunk

This page contains the following tables:

  • Stream Control Table: Contains the parameters Tx Stream Enable, Tx Stream IP Trunk A-B, Tx Stream UDP Trunk A-B, Tx Stream Type, Tx Stream Rate Limit, and Tx Stream Port Map.
  • NAT Control Table: Contains the parameters Input IP, Input Mode, IGMP Enable, IGMPv3, and IGMPv3 Source 1-6.
  • Status Table: Contains the parameters Tx Stream Present, Tx Stream Data Rate, IP Input Mode, IP Input RTP Type, and IP Input Packet Size.

Trunk to Access

This page contains the following tables:

  • Control Table: Contains the parameters Rx Stream Enable, Rx Stream IP Trunk A-B, Rx Stream UDP Trunk A-B, Rx Stream Mode, Rx Stream Type, Rx Stream Rate Limit, Rx Stream Port Map, and Protection Depth.
  • Control IGMP Table: Contains the parameters Rx IGMP Enable Trunk A-B, Rx IGMPv3 Mode Trunk A-B, and Rx IGMPv3 Source 1-6 Trunk A-B.
  • Control NAT Table: Contains the parameters Output IP and Output UDP.
  • Status Table: Contains the parameters Rx Stream Present Trunk A-B, Rx Stream Data Rate, Rx Stream Mode, Rx Stream Packet Size, Rx Stream Lost Packets, Rx Stream Protected Packets, Rx Stream Unprotected Packets, and Stat Clear.

Notification

This page contains the following tables, which each contain the parameters Fault, Send Trap, and Status:

  • Access Port Fault Present Table
  • Trunk Port Fault Present Table
  • Video Decap Fault Present Table
  • Video Encap Fault Present Table
  • System Status Fault Present Table
Improve this page