Evertz 7x00 General Platform Group 2 - 7700ACO2HD

About

The Evertz 7700ACO2HD card is a smart automatic changeover (ACO) for high-definition 1.5 Gb/s or standard-definition 270 Mb/s serial digital video signals. It provides dual processing paths on a single module, smart HD/SD-SDI automatic protection switching of both paths, video and audio proc amp control, and more.

An SNMP connection is used to retrieve and configure the information of the card. There are also different possibilities available for alarm monitoring and trending.

This connector is automatically generated by the parent connector Evertz 7x00 General Platform Group 2.

Configuration

This connector is used by DVEs that are automatically created by the parent element. No user input is required.

How to Use

General

This page contains the Detected Gen Standard, FPGA Build Number, etc. There is also a Reset button available.

Video

This page contains information about the video, including the Input Standards, Video Control Table and Video Processing Table.

Important note: The Video Control Table's "Video Switch Mode" and "Program Output" columns are modeled to match the behavior of the actual device. This means that when Video Switch Mode is set to "Auto Switch" or "Auto Switch Back", you can change the Program Output from "Input 2" to "Input 1", but not the other way around.

Audio

This page contains the Audio Control Table and the Audio Embedder Control Table.

IntelliAnalyzer

This page contains the Intelli Gain Config Table, Intelli Analyzer Channel Config Table, and Intelli Analyzer Config Table.

Alarms

This page contains information regarding alarms in the Misc Fault Table and IntelliAnalyzer Alarms Table.