Evertz FC3000
This connector monitors the Evertz FC3000, a controller card.
About
The module provides a single point of access to communicate with the entire 3000MVP series of cards. All the monitoring and control information is retrieved via SNMP.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version. Extra parameters added | No | No |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 2.8 |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device, e.g., 10.150.3.3.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device. The default value is public.
- Set community string: The community string used when setting values on the device. The default value is public.
Usage
The connector contains only one page.
General
This page contains two tables, two blocks of parameters and a page button.
The blocks of parameters display the Software and Hardware Information respectively.
The Power Supply page button displays four parameters: Power Supply 1 Status, Power Supply 2 Status, Power Supply 1 and Power Supply 2.
The Management Fault Table contains the following fault information:
- Fault Name
- Send Trap (used to decide if a trap must be sent)
- Fault Present
The Production Location Table is indexed by product location instance and contains information on the insertion/removal counters, product name and the starting/ending slots.