Evertz MVP OV - Channel
The MVP is a multi-image display and monitoring system. It provides a highly flexible, intuitive and comprehensive approach to virtual wall monitor applications. With the MVP, any input signal can be displayed on any output monitor without the need for DAs or upstream monitor routers.
About
This protocol is created by the Evertz MVP OV connector. For each bus address (1-8), the Evertz MVP OV creates a DVE.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | SNMP set not working | ||
| 2.0.0.x | Use of DVEs for each bus address instead of using the bus address to look at a single channel | - | - |
Supported Firmware Versions
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | Unknown |
| 2.0.0.x | Unknown |
Installation and Configuration
Configuration
The DVE is created by the parent connector protocol (Evertz MVP OV). It uses the name of the parent connector + the bus addres + the bus name. e.g., ParentName.1_BusName
You can change the bus name in the HardwareControl Table on the parent connector.
Usage
Input
On this page, you can monitor VistaLINK parameters, such as Loss of Video Sync, EDH Errors, Picture settings and Loss of Audio and the Input setting control parameters.
Notifications
This page displays two tables, the Video and Audio Notifications Tables.
Video Fault
This page displays general parameters related to errors, such as Error Duration Video, CC(1,2,3) Errors, Text Error, VITC Errors.
Audio Fault
This page displays the Audio Definition and Audio Pair Definition Tables.
Hardware Control
On this page, general parameters are consolidated: System Status, Tag Selector, Input Tags (A and B), Trap Tag and MVP IDs. The input + bus name is used to create the DVE.
Audio Loudness
On this page, you can configure the Loudness Measure Audio Program (1 to 8) and Audio Loud settings.
Audio Notifications
This page displays the Management Fault Audio 2 and Management Audio 3 Tables.
Dolby E
This page displays the Dolby E definition Table.
Group 7 Notifications
This page displays the Group 7 Notifications Table.
WST GPI
On this page, you can configure the WST GPI parameters.
EIA 708
On this page, you can configure the EIA 708 fault definition parameters.
Monitor Control
On this page, you can configure the Monitor Control parameters such as Start, Stop, Reset, ... of monitoring/reporting of faults.
RCTL GPI
On this page, you can configure the RCTL GPI Timecode parameters.
SCTE 104 GPI
On this page, you can configure the SCTE 104 GPI error on time.