Table of Contents

Factum EPC100

The Factum EPC100 connector displays information related to the Factum EPC100 Controller device.

About

This connector uses an SNMP connection to communicate with the Factum EPC100 device.

Installation and configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP Connection:

  • IP Address/host: The polling IP of the device, e.g., 10.145.1.12.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string required to read from the device. The default value is public.
  • Set community string: The community string required to set to the device. The default value is public.

Usage

General Page

This page displays status parameters such as the Agent Version, System Contact, etc.

Status Page

This page displays the main status of the device.

GPS Page

This page displays a table with device statuses.

Improve this page