Fraunhofer DRM Content Server
This connector is able to retrieve and set data on the Fraunhofer content server through SNMP.
About
Version Info
| Range | Key Features | Based On | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
| 1.0.1.1 | New MIB support. | 1.0.0.1 | New primary key within the Status table. |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
| 1.0.1.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
- Bus address: The bus address of the device. By default, this is not used.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
On the General page, you can find basic configuration parameters like system time, system version, etc.
The page also includes the very important Configuration parameter, which allows you to start or stop the transmission. You can also reboot the content server, and more.
You also can verify the status of every existing module, including timestamps, results and messages.
On the Broadcast Activation page, you can configure the Broadcast Configuration ID. Note that at the moment only sets are possible for this specific parameter.