GatesAir Flexiva M3FM-TX 1P1
The GatesAir Flexiva M3M-TX 1P1 is a solid-state transmitter that provides a single transmission platform capable of analog and digital operation.
About
This is an SNMP-based connector for the GatesAir Flexiva M3M-TX 1P1.
Version Info
| Range | Description |
|---|---|
| 1.0.0.x | Initial version |
| 1.0.1.x | Added support for DVEs |
Product Info
| Range | Device Firmware Version |
|---|---|
| 1.0.0.x | 02.03.0139 / 861-1151-162 S (software version) |
| 1.0.1.x | 02.03.0139 / 861-1151-162 S (software version) |
Exported connectors
| Exported Connector | Description |
|---|---|
| GatesAir Flexiva M3FM-TX 1P1 Main Transmitter | Main transmitter |
| GatesAir Flexiva M3FM-TX 1P1 Backup Transmitter | Backup transmitter |
Installation and configuration
Creation
SNMP main connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device. The default value is public.
- Set community string: The community string used when setting values on the device. The default value is private.
Usage
This connector monitors basic parameters. It can also receive traps from the device, so that values can be displayed immediately.
The connector contains 4 pages and a page with the device web interface.
General Page
This page displays information regarding the device itself, such as System Description, Uptime, Contact Name and Location.
System Page
This page displays information concerning the status of the Controller and the Switch. It is also possible to configure the System Name, System Power Control, Monitor Mode, Mode Control, Switch and Event settings.
Transmitter A and Transmitter B Pages
These pages contain the transmitter status and configuration for the corresponding transmitter.
They display the Communication, Frequency, Summary Faults, Remote Control, Drive, PA, Out and Aural Out status.
Both pages have two page buttons:
- Transmitter Config: Transmitter settings of Trip Level, Warning Level and Trip Time.
- Transmitter Events: Transmitter Event settings.
Web Interface
This page displays the web interface of the device.
Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.