GeoSync Microwave 1+1 RCU LNA Series
This connector is used to monitor and control a GeoSync Microwave 1+1 RCU Low-Noise Amplifier (LNA).
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 2.00_R100 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
- IP address/host: The polling IP of the device e.g., 10.11.12.13.
- IP port: The IP port of the device.
- Bus address: The address used by the serial interface. The default bus address is 64 (range: 64-95).
How to Use
On the General page, you can find comprehensive information about the Low-Noise Amplifier (LNA) switch.
On the remaining pages, you can control and monitor the status of the LNA switch.
On the Log page, you can review all the recorded log entries generated by the device. The log table is updated at a low frequency. To manually update the table, you can use the Refresh button. With the Clear button, you can remove the log entries.