GeoSync Microwave TRR-Ku2
These Test Translators are designed for applications where frequency translation is needed with a minimum of amplitude and group delay distortion. A level control of 30 dB is provided at the front panel in "local mode" or on the remote bus in "remote mode".
About
The GeoSync Microwave TRR-Ku2 connector controls and monitors the bands and attenuation of the device.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial Version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 2.01 |
Installation and configuration
Creation
SNMP main connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Usage
General
The Model, Serial Number, Firmware Revision, and Remote Mode are displayed at the top of the page.
The Band, Output State, Attenuation, Reference Frequency Adjustment, and Title can all be configured as well.
Information for the LO Frequency, High Input and Output Frequency Ranges as well as the Reference Frequency Source is also found on this page.
System Info
Generic system information such as the System Name, Temperature, 12V Power Supply, and Elapsed Time are on this page.
The User Generated Test, Local Oscillator, Power Supply, and Temperature Alarms are displayed on this page. The user can test alarms using the User Test Alarm buttons.
Log
The Log Events table is displayed on this page. The number of Log Entries is displayed at the top.
The entries can be cleared using the Clear button.
Network
The IP Address, Subnet Mask and Gateway can be configured and applied on this page.
The SNMP Read and Write Communities are configurable, as well as the Trap Interval and Destination.
Web Interface Page
This page displays the web interface of the device.
Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.